Need metal roof coating in Ardmore? Lapolla Industries provides free inspections, transparent pricing, and warranted spray foam solutions across OK.
Metal roofs in Ardmore, OK leak at fasteners, seams, and panel overlaps — and rust compounds the problem over time. Lapolla Industries applies elastomeric coating systems that seal every failure point, treat existing rust, and create a continuous waterproof membrane over your entire metal roof.
In Ardmore, OK, the difference between a spray foam job that lasts and one that fails comes down to the contractor. Lapolla Industries applies the same quality standards to every metal roof coating project that earned us a reputation as one of the nation's most trusted SPF specialists — proper surface prep, correct foam thickness, and factory-specified coating application.
Every metal roof coating project we complete in Ardmore is backed by both manufacturer material warranties and our own workmanship guarantee. We document every step with photos and measurements, provide you with a detailed project report, and remain available for warranty service and maintenance throughout the life of your SPF system.
Our proven process ensures quality results on every spray foam project.
Our assessment process goes beyond a visual check. We examine substrate conditions, drainage patterns, existing insulation performance, and structural integrity. This data-driven approach ensures we recommend the right spray foam solution for your specific property.
Our preparation process includes substrate inspection, cleaning, moisture testing, and priming. We mask all areas not receiving foam, set up containment where needed, and verify that temperature and humidity conditions are within specification for application.
Our factory-trained crews apply spray polyurethane foam using calibrated equipment that ensures consistent thickness, proper density, and complete coverage. The foam expands on contact, fills every gap, and bonds permanently to the prepared substrate.
The final step is applying a protective topcoat that shields the SPF from UV exposure and provides the weather surface. We select the coating type based on your roof slope, ponding conditions, and desired service life. After coating, we clean up completely and review the finished project with you.
Common questions about metal roof coating answered by our spray foam experts.
Costs for metal roof coating in Ardmore vary based on project size, existing conditions, and material requirements. We provide free on-site estimates with detailed written proposals. Contact us at {phone} for a no-obligation quote.
Yes. Every metal roof coating project in Ardmore starts with a free, no-obligation inspection and detailed written estimate. Call {phone} to schedule yours. There is never a charge for the initial assessment.
Yes. Every Lapolla Industries crew working in Ardmore is fully licensed, bonded, and insured for spray foam application. We carry general liability and workers compensation coverage on every project and can provide proof of insurance upon request.
Absolutely. Once cured, spray polyurethane foam is inert and non-toxic. Our Ardmore crews follow all OSHA safety protocols during application, including full PPE and ventilation procedures. The foam cures within minutes and is safe immediately after.
Honest reviews from property owners who chose Lapolla Industries for their roofing and insulation needs.
"We converted our old built-up roof to spray foam and could not be happier. The insulation value alone has cut our HVAC costs significantly. The crew explained every step and left the site spotless."
"Attic insulation upgrade from blown-in to spray foam. The crew masked everything off properly and the overspray was minimal. The temperature in our attic dropped dramatically and so did our energy bills. Worth the investment."
"They waterproofed our entire flat roof with a seamless elastomeric membrane. Two years later and not a single drop of water has gotten through. The application was clean and fast — three days for 8,000 square feet."